Oval,
Elliptical, and Odd Radius Casing:
Make sure
the template fits exactly inside the radius edge. Multiply the rise
times 3 and add the width, next round up to the next even footage
to get material length needed.
Round
Column, Crown and Base Molding:
Determine
the exact diameter width of the column (1/2, 3/4 or FULL coverage)
next determine length needed and add 2 feet to calculate the material
length needed.
Irregular
Radius Crown:
Make
a template that fits against the wall curve or fits to the outside
edge of the dormer and mark the template with the molding position
information this is important (check orientation
page if not sure), don't disregard this factor. Determine
length needed and add 2 feet (for waste factor).
|
|
|
|
|
CROWN
AND BASE MOLDING LIMITATIONS
1. Minimum 36" radius for profiles 8” to 10" wide and no restricted flexibility because of the molding
width
2. Minimum 24" radius for profiles 6" to 8" wide, and the profile will flex 2" larger or smaller
3. Minimum 18" radius for profiles 5" to 6" wide, and the profile will flex 3" larger or smaller
4. Minimum 12" radius for profiles 4" to 5" wide, and the profile will flex 4" larger or smaller
5. Minimum 8" radius for profiles 3" to 4" wide, and the profile will flex 5" larger or smaller
6. Minimum 6" radius for profiles 2" to 3" wide, and the profile will flex 6" larger or smaller
ELLIPTICAL
OUTBOARD RADIUS LIMITATIONS
1. Minimum 16" radius if the profile is 6" to 8" wide
2. Minimum 12" radius if the profile is 5" to 6" wide
3. Minimum 10" radius if the profile is 4" to 5" wide
4. Minimum8" radius if the profile is 3" to 4" wide
5. Minimum 6" radius if the profile is 2" to 3" wide |
|
Rise"
x 3 + width" = MATERIAL LENGTH
|
|
|
|
|
|
1/2
column: Rise"
x 3 + width" = MATERIAL LENGTH
|
|
|
|
|
|
1/2
column:
Diameter" round up to nearest EVEN footage + 2' = MATERIAL
LENGTH
|
|
